Skip to main content

40M Junk Box SSB Transceiver Microphone Amplifier

Exploring PNP Transistor Microphone Amps


This is a first for me in terms of using PNP transistors for microphone amps. In fact more recently it was a first for me to use a single NPN transistor as a microphone amp. For the longest time my standard building block was the NE5534 for microphone amps.
 
On the air signal reports for the Junk Box rig were very good with the added comment that there seemed to a favoring of the highs with very little in the way of low frequencies. Well Duh, a couple of minutes with an LT Spice Simulation confirmed the why this was so. This post will explore the why.
 
[I should note that I have a bag of vintage PNP audio type transistors that I have often wondered what can be done with these treasures of old? Now I know!]
 
I ginned up the circuit I was initially using and it worked and just moved on but given the reports of the lack of lows I actually simulated the original circuit and found that there was a substantial lack of gain (like 10 to 15 dB) for frequencies below 1 KHz. Above that frequency things were much better.
 
Since there were no LT Spice Library entries for the 2N996 I picked the 2N4403 and then verified the same results with a 2N3906. Two capacitors play a key role in boosting the low end response and those are C1 and C4. Initially I had C1 at 100NF and C4 was 10 ufd and of course we could see that lack of the low end response. With a bit of cut and try these final values of 10 and 100 ufd, really boosts the low end. Now there is less than about a 3 dB change from 300 to 3000 hertz. I used a generator with a 100 millivolt output and swung the frequency from 10 hertz to 5000 hertz.
 
For those picknitters in the readership the + side of the 10 ufd is toward the signal input and the minus toward the base. On the 100 ufd, the + side is connected to the emitter of the device. I installed a socket on this board so I can actually turn this into a PNP transistor checker. For those who are still uncertain about electrolytic cap polarity-- the answer is to purchase and install non-polarized electrolytic capacitors.
 
A little more than the 15 minutes I spent with LT Spice could even further improve the low end so that the circuit is flat to 5 kHz. At this point I say Basta and just move on.


Schematic of the PNP Microphone Amplifier

Finally for the doubting Thomas crowd here is the expected performance of the circuit. I should also caution that R4 is really a 10K Trim Pot and the 220 NF (0.22 ufd) cap is connected to the center wiper. The output end of the 220 NF is paralleled with the audio amp input where both are connected to pins 3& 4 of the SBL-1.

Projected Output from the PNP Microphone Amplifier Stage.

 
The bottom line is that the PNP Microphone amplifier stage is good for about 20 dB of gain over the audio range and confirms the suitability of the device in homebrew SSB transceiver projects. Somehow many of us sort of gravitate to NPN devices --but good circuits can be built using PNP devices.
 
73's
Pete N6QW

Popular posts from this blog

2019 ~ What is the simplest homebrew SSB Transceiver that can be built?

4/27/2019 The Future of our Hobby is Here! Forget those simple rigs with homebrew crystal filters, cranky IRF510's and the analog VFO's. SDR is the wave that is building strength just like a Tsunami. With the Soft Rock V6.3 SMD Version + RRPi2 With the Omnia SDR and RPi2 Pete N6QW How Simple & How Cheap can you  build a Homebrew SSB Transceiver? 4/26/2019 --- I just converted my websites from an obsolete Windows Based Server with GoDaddy to their cPanel (Linux). This was a cost issue as a one year renewal of the Windows Server would buy three years on the cPanel. GoDaddy is discouraging the use of what they call the Obsolete Windows System. So I had to migrate and reload the whole pastapete.com, jessystems.com and the n6qw.com sites to the Linux based servers. Some files and links got lost in the translation --so you might not be able to see everything! Essentially I have  to open every link to verify that it works --that may take some time

New Technology for 2020 ~ The Hermes Lite 2.0 SDR Transceiver

  The Hermes Lite 2.0 SDR Transceiver. November 7th, 2020 ~ It's Settled! It is done! The stain of the Trump era is soon to be removed! Thanks to all who voted. The Voice of the People has been heard.  Congratulations to President Elect Biden and Vice President Elect Harris. Pete N6QW November 3rd, 2020 -- IT WAS THE MOUSE   We all know this is Dump Trump  Day. Go out and vote! It was the mouse! Back in 1999 I stupidly was one of the very first to purchase a Ten Tec Pegasus. Never buy the first batch of a new model.  Touted as the world's first computer controlled radio , actually I think the Kachina 505 was really the first. But the Pegasus was fraught with problems including a trip back to the Smokey Mountains. I was using an older Windows 95 machine to control the Pegasus and that may be a co-conspirator. Well after many calls to TT -- finally someone who has some smarts told me: Fix your station ground, Make all leads short and Buy stock in a ferrite bead company. I did all

The Next Project Updated 10/10/2022! The rubber has hit the pavement!

The Next Project... A 2022 Transceiver. 10/10/2022 My Apologies. It is with regret that I will be terminating any further work on this project. My caregiver duties have over time become a greater time sink and it is almost impossible to build something working only 10-15 minutes at a time spread out over a day. I apologize for not getting it from design ideas to complete hardware. Most likely I have built the last transceiver I will ever build. Thanks for riding along. My website https://www.n6qw.com/  has the pdf of the postings and I will leave this blog page as is. 73's Pete N6QW 10/05/2022 Still Alive! Regrettably my caregiver duties have overtaken any free time so not much progress. But I am hopeful yet this week I will cut at least one board. A PSA from N6QW.  Think of it like Mary Jo has a "crink" in her back and unable to get in the backseat of the 57 VW Beetle. A bit of a setback but not forever.  Seems like the hired caregiver had a small emergency and not able